Hmoe > Automatic Planer & Moulder > Moulder


1. 4-side 7 spindle moulder (8 spindle + 1 multiple ripsaw combination)

Max. working width x thickness: 230 x 125mm
Hard chrome table plates.
Mechanical digital readouts for spindle adjustment.
Central lubrication points for all spindles.
Full sound and safety enclosure.
Pneumatic controlled feed rollers.
Full cardan shaft drive to feed works.
Individual motor to each spindle.
All spindles have horizontal and vertical adjustments.
Spring loaded top idle roller pressures at each fenceside position.
Auto bed lubrication to increase feed power and reduce table wear.
2 meter infeed table.
Lateral pressure roller at the infeed.
6000 RPM of spindle, spindle diameter 40mm.
Variable feed speed from 6 30 M/min by frequency inverter
Spindle configuration & motor: Bottom 10HP, Right 7.5HP, Left 7.5HP, Top 15HP, Right 7.5HP, Left 7.5HP,Top 15HP (Straight pneumatic/electric driven Jointer + Hydro outboard bearing), Bottom 15HP(Straight pneumatic/electric driven Jointer + Hydro outboard bearing) , Multiple ripsaw 50HP (rip max. thickness 110mm and mount 4 blades).
Each spindle motor is with brake motor.
Pneumatic side rollers before each left vertical spindle
Pneumatic chip breaker before each top spindle.
Device for short pieces x 2 sets
Cutterhead with changeable knives: 4 x dia. 125 x 100 + 4 x dia. 125 x 200